COLDER pad for either the refrigerator or freezer.
The SET light will illuminate on the side you selected. Then press the COLDER pad again (on the side where the SET light is illuminated) and it will go to the preset points of 0F for the freezer and
37F for the refrigerator. Setting either or both controls to OFF stops cooling in both the freezer and refrigerator compartments, but does not shut off electrical power to the refrigerator.
Performance Air Flow System
The Performance Air Flow System is designed to maximize temperature control in the refrigerator and freezer compartments. This unique special feature consists of the Air Tower along the back wall of the refrigerator and the Air Tunnel on the bottom portion of the freezer rear wall. Placing food in front of the louvers on these components will not affect performance.
Troubleshooting Tips
Once the desired temperature has been set, the temperature display will return to the actual refrigerator and freezer temperatures after 5 seconds. Several adjustments may be required.
Each time you adjust controls, allow 24 hours for the refrigerator to reach the temperature you have set.
Installation Instructions
Changing the Temperature
Operating Instructions
NOTE: The refrigerator is shipped with protective film covering the temperature controls.
If this film was not removed during installation, remove it now.
Safety Instructions
About the controls with temperature settings. (for other models, see next page)
Consumer Support
Safety Instructions
Operating Instructions
About the controls with numbered settings.
NOTE: The refrigerator is shipped with protective film covering the temperature controls.
If this film was not removed during installation, remove it now.
Installation Instructions
Initially, set the refrigerator control at 5 and the freezer control at 5 and allow 24 hours for the temperature to stabilize.
Several adjustments may be required. Adjust the controls one increment at a time, and allow 24 hours after each adjustment for the refrigerator to reach the temperature you
Setting either or both controls to 0 stops cooling in both the refrigerator and freezer compartments, but does not shut off electrical power to the refrigerator.
Performance Air Flow System
Consumer Support
Troubleshooting Tips
The Performance Air Flow System is designed to maximize temperature control in the refrigerator and freezer compartments. This unique special feature consists of the Air Tower along the back wall of the refrigerator and the Air Tunnel on the bottom portion of the freezer rear wall. Placing food in front of the louvers on these components will not affect performance.
Water Filter Cartridge
Filter Bypass Plug
The water filter cartridge is located in the back upper right corner of the refrigerator compartment.
You must use the filter bypass plug when a replacement filter cartridge is not available.
The icemaker will not operate without the filter or filter bypass plug.
When to Replace the Filter
Installing the Filter Cartridge
If you are replacing the cartridge, first remove the old one. Open the cartridge cover by pressing in on the tab at the front and pulling down.
Remove the cartridge by slowly rotating it counterclockwise. A small amount of water may drip down.
Replacement Filters:
To order additional filter cartridges in the United States, visit our Website,
GE Parts and Accessories, 800.626.2002.
Operating Instructions
The filter cartridge should be replaced every six months or earlier if you notice your ice cubes becoming smaller.
Safety Instructions
About the water filter. (on some models)
Filter Model GSWF
Suggested Retail Price $34.95 USD
Customers in Canada should consult the yellow pages for the nearest Camco
Service Center.
Installation Instructions
If air has been trapped in the system, the filter cartridge may be ejected as it is removed. Use caution when removing.
Mark you calender or apply the month and year sticker, to remind you to replace the filter cartridge in six
Remove the protective foil from the end of the cartridge.
Troubleshooting Tips
