? Clean the cooktop with caution. If a wet sponge or cloth is used to wipe spills on a hot surface element, be careful to avoid steam burns. Some cleansers can produce noxious fumes if applied to a hot surface.
? NOTE: We recommend that you avoid wiping any surface element areas until they have cooled and the indicator light has gone off.
Sugar spills are the exception to this. Please see the Cleaning the Glass Cooktop section.
? To avoid possible damage to the cooking surface, do not apply the cleaning cream to the glass surface when it is hot.
? After cleaning, use a dry cloth or paper towel to remove all the cleaning cream residue.
? Read and follow all instructions and warnings on the cleaning cream labels.
? Use care when touching the cooktop. The glass surface of the cooktop will retain heat after the controls have been turned OFF.
? Do not stand on the glass cooktop.
? Large scratches or impacts to glass cooktops can lead to broken or shattered glass.
Read and follow this Safety Information carefully.
SAVE THESE INSTRUCTIONS
Features of your 36 cooktop.
Throughout this manual, features and appearance may vary from your model.
PP972, CP650
Feature Index (Features and appearances may vary.)
Explained on page
Single Surface Element
Dual Surface Element
Tri-Ring Surface Element
Left Rear Surface Element Control Knob
Warming Zone Surface Element
Control Lock Indicator Light
Surface Element ON Indicator Light
Center or Tri-Ring Surface Element Control Knob
Dual Surface Element Control Knob
Right Rear Surface Element Control Knob
Control Lock Knob
Left Front and Bridge Surface Element
Bridge/Left Front Surface Element Control Knob
Features of your 30 cooktop.
Throughout this manual, features and appearance may vary from your model.
PP944, CP350
Feature Index (Features and appearances may vary.)
Single Surface Element
Dual Surface Element
Left Rear Surface Element Control Knob
Left Front Surface Element Control Knob
Control Lock Indicator Light
Surface Element ON Indicator Light
Dual Surface Element Control Knob
Dual Surface Element Selector Knob
Right Rear Surface Element Control Knob
Control Lock Knob
Left Front and Bridge Surface Element
Bridge Surface Element Selector Knob
Tri-Ring Surface Element
Explained on page
Tri-Ring Surface Element Selector Knob
Tri-Ring Surface Element Control Knob
Left Front/Bridge Surface Control Knob
Center Rear Surface Element Control Knob
Using the surface elements.
Throughout this manual, features and appearance may vary from your model.
How to Set
Push the knob down and turn in either direction to the setting you want. When the control is in any position other than OFF, it may be rotated without pushing it down.
A HOT SURFACE indicator light will glow when any radiant element is turned on and will remain on until the surface is cooled to approximately 150F.
At both OFF and HI the control clicks into position. You may hear slight clicking sounds during cooking, indicating the control is keeping the power level you set.
? It comes on when the element is hot to the
? It stays on even after the element is turned off.
? It glows brightly until the element is cooled to approximately 150F.
? Be sure you turn the control knob to OFF when you finish cooking.
The controls for the radiant surface elements can be set anywhere between LO and HI for an unlimited number of heat settings. With the infinite switch the element cycles on and off
