GE Profile™ 20.8 Cu. Ft. Counter-Depth French-Door Refrigerator PFIC1NFWBV user guide

Turbo Cool setting.
The temperature display will return to the actual refrigerator and freezer temperatures after 5 seconds. Several adjustments may be required.

Each time you adjust controls, allow 24 hours for the refrigerator to reach the temperature you have set.

To turn the cooling system off, tap the WARMER pad for either the refrigerator or the freezer until the display shows OFF. To turn the unit back on, press the

COLDER pad for either the refrigerator or freezer.

Then press the COLDER pad again and it will go to the preset points of 0F for the freezer and 37F for the refrigerator. Setting either or both controls to OFF stops cooling in both the freezer and refrigerator compartments, but does not shut off electrical power to the refrigerator.

How it Works

(on some models)

Once activated, the compressor will turn on immediately and the fans will cycle on and off at high speed as needed for eight hours.

The compressor will continue to run until the refrigerator compartment cools to approximately 34F (1C), then it will cycle on and off to maintain this setting. After 8 hours, or if TurboCool is pressed again, the refrigerator compartment will return to the original setting.

How to Use

Press TurboCool. The refrigerator temperature display will show .

After TurboCool is complete, the refrigerator compartment will return to the original setting.

NOTES: The refrigerator temperature cannot be changed during

TurboCool.

Operating Instructions

(on some models)

TurboCool rapidly cools the refrigerator compartment in order to more quickly cool foods. Use TurboCool when adding a large amount of food to the refrigerator compartment, putting away foods after they have been sitting out at room temperature or when putting away warm leftovers. It can also be used if the refrigerator has been without power for an extended period.

The freezer temperature is not affected during TurboCool.

When opening the refrigerator door during TurboCool, the fans will continue to run if they have cycled on.

Installation Instructions

About Door Alarm (on some models)

The door alarm will sound if any

People who looking for PFIC1NFWBV also looking

door is open for more than 2 minutes.

The beeping stops when you close

(on some models)

Troubleshooting Tips

(on some models)

About Energy Saver (on some models)

This product is equipped with an Energy

Saver feature. The refrigerator is shipped with the Energy Saver feature enabled.

Over time, moisture can form on the front surface of the refrigerator cabinet and cause rust. If moisture does appear on the front surface of the refrigerator cabinet, turn off the Energy Saver feature by pressing and releasing the ENERGY SAVER pad on the control panel.

Consumer Support

(on some models)

Safety Instructions

About TurboCool. (on some models)

(on some models)

Water Filter Cartridge

Filter Bypass Plug

The water filter cartridge is located in the back upper right corner of the refrigerator compartment.

You must use the filter bypass plug when a replacement filter cartridge is not available.

The icemaker will not operate without the filter or filter bypass plug.

When to Replace the Filter

There is a replacement indicator light for the water filter cartridge on the temperature display. This light will turn orange to tell you that you need to replace the filter soon. The filter cartridge should be replaced when the replacement indicator light turns red or if the flow of water to the dispenser or icemaker decreases.

Operating Instructions

Safety Instructions

About the water filter. (on some models)

Installing the Filter Cartridge

Installation Instructions

If you are replacing the cartridge, first remove the old one. Open the cartridge cover by pressing in on the tab at the front and pulling down.

Remove the cartridge by slowly rotating it counterclockwise. A small amount of water may drip down.

If air has been trapped in the system, the filter cartridge may be ejected as it is removed. Use caution when removing.

Troubleshooting Tips

Remove the protective foil from the end of the cartridge.

(on some models)

Lining up the arrow on the cartridge and the cartridge holder, slowly rotate the cartridge clockwise until it stops.

When the cartridge is properly installed, you will feel it click as it locks into place. The grip on the end of the cartridge should be positioned vertically. Do not overtighten.

Close the cartridge cover.

Run water from the dispenser for

3 minutes (about 11?2 gallons) to clear the system and prevent sputtering.

See To Use the Dispenser section.

Press and hold the RESET WATER FILTER pad for 3 seconds.

Consumer Support

(on some models)

NOTE: A newly-installed water filter cartridge may cause water to spurt from the dispenser.

Replacement Filters:

To order additio