GE® 115 Volt Room Air Conditioner AKM05LN user guide

EZ Mount window installation kit included.
Setting. Hold down both the up and down pads for 5 seconds to change the display between Fahrenheit and Celsius.

Delay Timer Increase ? / Decrease ? Pads

Each touch of the Increase ? / Decrease ? pads on the unit or on the remote control will set the delay time when using the Delay 124hr timer. The Set light will turn on while setting.

Fan Speed Pad

Use to set the fan speed to Low, Med, High or Auto on the unit. NOTE: On the remote control, use the Fan button to set the fan speeds to Low, Med, High or Auto.

Turns air conditioner on and off. When turned on, the display will show the room temperature.

Delay Pads

Delay OFFWhen the air conditioner is on, it can be set to automatically turn off in 1 to

How to set:

Press the Delay 124hr pad on the unit or on the remote control. Each touch of the Increase

? / Decrease ? pads on the unit or on the remote control will set the timer in 1/2-hour intervals until the time reaches 10 hours; then it will increase in 1-hour intervals. The Set light will turn on while setting.

To review the remaining time on the Delay

124hr timer, press the Delay 124hr pad on the unit or on the remote control. Use the

Increase ? / Decrease ? pads on the unit or on the remote control to set a new time if

To cancel the timer, press the Delay 124hr pad until the light on the Delay 124hr pad goes off.

Clean Filter

The Clean Filter light will come on to tell you it is time to change your filter.

Do Not Operate in Freezing Outdoor Conditions

This cool-only air conditioner was not designed for freezing outdoor conditions. It must not be used in freezing outdoor conditions.

? To ensure proper operation, aim the remote control at the signal receiver on the air conditioner.

? The remote control signal has a range of up to 20 feet.

Cooling Descriptions

For Normal CoolingSelect the Cool mode and

High or Med fan with a middle set temperature.

For Maximum CoolingSelect the Cool mode and High fan with a lower set temperature.

For Quieter and Nighttime CoolingSelect the

Cool mode and Low fan with a middle set temperature.

Care and Cleaning

Installation

Instructions

Use the Cool mode at Low, Med, High or Auto Fan

Speed for cooling. Use the Temperature Increase ? /

Decrease ? pads to set the desired temperature between 62F and 86F in 1F increments.

An electronic thermostat is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the set level of comfort.

Set the thermostat at a lower number and the indoor air will become cooler. Set the thermostat at a higher number and the indoor air will become warmer.

NOTE: If the air conditioner is off and is then turned on while set to a Cool setting or if turned from a fan setting to a Cool setting, it may take approximately 3 minutes for the compressor to start and cooling to begin.

? Make sure nothing is between the air conditioner and the remote control that could block the

? Make sure batteries are fresh and installed correctly as indicated on the remote control.

Energy Saver Mode

Controls the fan.

ONThe fan will cycle on and off with the compressor. This results in wider variations of room temperature and humidity. Normally used when the room is unoccupied. NOTE: The fan may continue to run for a short time after the compressor cycles off.

OFFThe fan runs all the time, while the compressor cycles on and off.

NOTE: Auto Fan Speed is available in the Fan Mode.

Auto Fan Speed

Set to Auto fan speed for the fan speed to automatically set to the speed needed to provide optimum comfort settings with the set temperature.

If the room needs more cooling, the fan speed will automatically increase. If the room needs less cooling, the fan speed will automatically decrease.

NOTE: Auto Fan Speed is available in the Fan Mode.

Power Outage Recovery Feature

In the case of a power outage or interruption, the unit will automatically restart in the settings last used after the power is restored. If the Delay 124hr feature was set, it will resume countdown. You may need to set a new time if desired.

Troubleshooting Tips Consumer Support

Use the Fan Mode at Low, Med or High fan speed to provide air circulation and filtering without cooling.

Since fan-only settings do not provide cooling, a

Set temperature cannot be entered. The room temperature will appear in the display.

Instructions

Remote Control

Safety Instructions

Additional important information.

Air Direction

Use the lever to adjust the air direction left and right only.

Instructions

Safety Instructions

About the controls on the air conditioner.

Fresh Air Vent Control (on some models)

The Fresh Air Vent Control allows you to let fresh air into the room.

To close the vent, push the tab in.

Consumer Support Troubleshooting Tips

Vent closed

Care and cleaning of the air conditioner.

Grille and Case

Turn the air conditioner off and remove the plug from the wall outlet before cleaning.

To clean, use water and a mild detergent. Do not use bleach or abrasives.

Air Filter

The air filter behind the front grille should be checked and cleaned at least every 30 days or more often if necessary.

Installation

Instructions

Care and Cleaning

To open the vent, pull the tab out to allow fresh air to circulate into the room.

To remove:

Open the inlet grille by pulling downward on the tabs at the top upper corners of the inlet grille until the grille is in a 45 position. Remove the filter.

Clean the filter with warm, soapy water. Rinse and let the filter dry before replacing it. Do not clean the filter in a dishwasher.

DO NOT operate the air conditioner without a filter because dirt and lint will clog i