How it Works
Once activated, the compressor will turn on immediately and the fans will cycle on and off at high speed as needed for eight hours.
The compressor will continue to run until the refrigerator compartment cools to approximately 34F (1C), then it will cycle on and off to maintain this setting. After
8 hours, or if TurboCool is pressed again, the refrigerator compartment will return to the original setting.
How to Use
Press TurboCool. The TurboCool indicator light will come on; however, the refrigerator temperature display will still show the current setting.
After TurboCool is complete, the TurboCool indicator light will go out.
NOTES: The refrigerator temperature cannot be changed during
TurboCool rapidly cools the refrigerator compartment in order to more quickly cool foods. Use TurboCool when adding a large amount of food to the refrigerator compartment, putting away foods after they have been sitting out at room temperature or when putting away warm leftovers. It can also be used if the refrigerator has been without power for an extended period.
About the temperature controls.
The freezer temperature is not affected during TurboCool.
When opening the refrigerator door during TurboCool, the fans will continue to run if they have cycled on.
On some models
Water Filter Cartridge
The water filter cartridge is located in the back upper right
corner of the refrigerator compartment.
When to Replace the Filter on Models With a
Replacement Indicator Light
There is a replacement indicator light for the water filter cartridge on the dispenser. This light will turn orange to tell you that you need to replace the filter soon.
Line up the arrow on the cartridge and the cartridge holder. Place the top of the new cartridge up inside the holder. Do not push it up into the holder.
Slowly turn it to the right until the filter cartridge stops.
DO NOT OVERTIGHTEN. As you turn the cartridge, it will automatically raise itself into position. The cartridge will move about 1/2 turn.
The filter cartridge should be replaced when the replacement indicator light turns red or if the flow of water to the dispenser or icemaker decreases.
When to Replace the Filter on Models Without a
Replacement Indicator Light
The filter cartridge should be replaced every six months or earlier if the flow of water to the water dispenser or icemaker decreases.
Run water from the dispenser for 3 minutes
(about 1-1/2 gallons) to clear the system and prevent sputtering.
Removing the Filter Cartridge
Press and hold the RESET WATER FILTER pad
(on some models) on the dispenser for 3 seconds.
If you are replacing the cartridge, first remove the old one by slowly turning it to the left. Do not pull down on the cartridge. A small amount of water may drip down.
NOTE: A newly-installed water filter cartridge may cause water to spurt from the dispenser.
Installing the Filter Cartridge
If you are replacing a SmartWater cartridge with an adapter, the adapter must be removed before installing the cartridge. To remove the adapter, turn it to the left about 1/4 turn.
If you are replacing a Water by Culligan cartridge, leave the adapter in place. This adapter will stay in the refrigerator when you replace future cartridges.
About the water filter (on some models).
Filter Bypass Plug
You must use the filter bypass plug when a replacement filter cartridge is not available. The dispenser and the icemaker will not operate without the filter or filter bypass plug.
(appearance may vary)
On models without a replacement indicator light, apply the month and year sticker to the new cartridge to remind you to replace the filter in six months.
Fill the replacement cartridge with water from the tap to allow for better flow from the dispenser immediately after installation.
Water by Culligan
To use the filter bypass plug on Water by Culligan models, you must first remove the filter adapter from the cartridge holder by turning it to the left.
To order additional filter cartridges in the United States,
Suggested Retail $38.9547.95
Customers in Canada should consult the yellow pages for the nearest Mabe Service Center.
Not all features are on all models.
Refrigerator Door Bins and Freezer Door Tilt-Out Bins
The larger refrigerator door bins and freezer tilt-out door bins are adjustable.
To replace or relocate: Engage the back side of the bin in the molded supports of the door. Then push down on the front of the bin. Bin will lock in place.
To remove: Lift the front