GE Profile Arctica CustomStyle™ Side-By-Side Refrigerator PSI23MGNCC user guide

Slide-out, spillproof glass shelves.
Wall of the refrigerator and the Air Tunnel on the bottom portion of the freezer rear wall. Placing food in front of the louvers on these components will not

Troubleshooting Tips

Once the desired temperature has been set, the temperature display will return to the actual refrigerator and freezer temperatures after 5 seconds. Several adjustments may be required.

Each time you adjust controls, allow 24 hours for the refrigerator to reach the temperature you have set.

To turn the cooling system off, tap the WARMER pad for either the refrigerator or the freezer until the display shows OFF. To turn the unit back on, press the

COLDER pad for either the refrigerator or freezer.

The SET light will illuminate on the side you selected. Then press the COLDER pad again (on the side where the SET light is illuminated) and it will go to the preset points of 0F for the freezer and

37F for the refrigerator. Setting either or both controls to OFF stops cooling in both the freezer and refrigerator compartments, but does not shut off electrical power to the refrigerator.

Installation Instructions

To change the temperature, press and release the

WARMER or COLDER pad. The SET light will come on and the display will show the set temperature.

To change the temperature, tap either the

WARMER or COLDER pad until the desired temperature is displayed. Refrigerator temperatures can be adjusted between 34F and 44F and the freezer temperatures can be adjusted between

6F and +6F.

Operating Instructions

The temperature controls are preset in the factory at 37F for the refrigerator compartment and 0F for the freezer compartment. Allow

24 hours for the temperature to stabilize to the preset recommended

The temperature controls can display both the SET temperature as well as the actual temperature in the refrigerator and freezer.

The actual temperature may vary slightly from the SET temperature based on usage and operating environment.

Setting either or both controls to OFF stops cooling in both the freezer and refrigerator compartments, but does not shut off electrical power to the refrigerator.

NOTE: The refrigerator is shipped with protective film covering the temperature controls. If this film was not removed during installation, remove it now.

Safety Instructions

About the temperature controls.

How it Works

TurboCool rapidly cools the refrigerator compartment in order to more quickly cool foods. Use TurboCool when adding a large amount of food to the refrigerator compartment, putting away foods after they have been sitting out at room temperature or when putting away warm leftovers. It can also be used if the refrigerator has been without power for an extended period.

Once activated, the compressor will turn on immediately and the fans will cycle on and off at high speed as needed for eight hours.

The compressor will continue to run until the refrigerator compartment cools to approximately 34F (1C), then it will cycle on and off to maintain this setting. After

8 hours, or if TurboCool is pressed again, the refrigerator compartment will return to the original setting.

How to Use

Press TurboCool. The refrigerator temperature display will show TC.

After TurboCool is complete, the refrigerator compartment will return to the original

The refrigerator temperature cannot be changed during TurboCool.

The freezer temperature is not affected during


When opening the refrigerator door during

TurboCool, the fans will continue to run if they have cycled on.

About ClimateKeeper2.

How it Works

The new ClimateKeeper2 is the industrys most advanced refrigeration system, delivering optimum temperature and humidity performance to keep food fresh longer and reduce freezer burn, while maintaining E star-level efficiency.

Troubleshooting Tips

Installation Instructions

Operating Instructions

Safety Instructions

About TurboCool.

The new ClimateKeeper2 system features two evaporatorsone for the refrigerator and one for the freezer.

This provides two separate cooling systems for the entire unit, and separates the airflow between the fresh food and freezer sections during normal cooling operations.*

Consumer Support

This ensures that the humidity levels in the fresh food section are significantly higher than in a conventional system,** allowing fresh produce and other unsealed foods to retain their moisture content and freshness longer. Moisture sensitive foods such as fresh fruit, salads, rice, etc., can now be stored on open shelves without excessive moisture loss.

The separate airflow system