GE Profile Performance™ 25.6 Cu. Ft. Side-by-Side Refrigerator with Dispenser and Water By Culligan™ TFX26PPDWW user guide

LightTouch! dispenser - chilled water, cubes and crushed ice.
Hand while pulling the power cord plug with the other hand. If this is not done, the adapter ground terminal is very likely to break with repeated use.

If the adapter ground terminal breaks, DO NOT USE the refrigerator until a proper ground has been established.

Attaching the adapter ground terminal to a wall outlet cover screw does not ground the appliance unless the cover screw is metal, and not insulated, and the wall outlet is grounded through the house wiring. You should have the circuit checked by a qualified electrician to make sure the outlet is properly grounded.

Customer Service

Read and follow this Safety Information carefully.

SAVE THESE INSTRUCTIONS

Safety Instructions

About the controls on the refrigerator.

The controls will look like one of the following.

Initially set the fresh food control at 5 and the freezer control at 5 or C.

Fresh Food Control

5 is Initial Setting

9 is Coldest

Freezer Control

C is Initial Setting

E is Coldest

Installation Instructions

Fresh Food

Operating Instructions

If you want colder or warmer temperatures, adjust the fresh food temperature first. When satisfied with that setting, adjust the freezer temperature.

Troubleshooting Tips

Control Settings

Moving the control to OFF or 0 stops cooling in both areasfresh food and freezerbut does not shut off power to the refrigerator.

Fresh Food Control

The fresh food control maintains the temperatures throughout the fresh food compartment.

Freezer Control

The freezer control maintains the temperatures throughout the freezer compartment.

How To Test Temperatures

Use the ice cream test for the freezer compartment. Place a container of ice cream in the center of the freezer and check it after a day. If its too hard or too soft, adjust the temperature controls.

After changing the controls, allow 24 hours for the refrigerator to reach the temperature you have set.

Customer Service

Use the milk test for the fresh food compartment. Place a container of milk on the top shelf and check it a day later. If the milk is too warm or too cold, adjust the temperature controls.

On some models. The controls will look like one of the following.

The Electronic Monitor and Diagnostic System controls dispenser functions and monitors the operation of your refrigerator.

Operating Instructions

Safety Instructions

About the controls on the refrigerator.

DISPENSER PUSH BELOW

DOOR ALARM

Troubleshooting Tips

Installation Instructions

Monitor and Diagnostic System lights up to indicate that no failure has been detected by the diagnostic system. flashes when either door is open. lights up when freezer food-keeping temperature is above normal.

Flashing diagnostic codes. What these codes meanand what to do when they appearis explained more thoroughly on the following pages.

Customer Service

SYSTEM CHECK-RESET from the display.

Select CUBED ICE

DOOR ALARM reviews the diagnosis of four coded functions and allows you to erase codes

, CRUSHED ICE and the signal light confirms your choice. lights up when the beeper has been set to sound after either door has been open 30

All panel lights come on for five seconds, a beep sounds, and lights go off except as

? PF flashes in the display. Touch SYSTEM

CHECK-RESET to erase it.

? NORMAL glows.

? CRUSHED ICE glows.

? DOOR OPEN flashes if either door is open, goes out when doors are shut.

? Night light in ice and water dispenser

Operating Instructions

? WARM TEMP glows until the refrigerator cools down. It goes off when proper foodkeeping temperature is reached.

? Door alarm beeper is activated and DOOR

ALARM glows.

How to Set the Door Alarm

DOOR ALARM

To set the alarm press DOOR ALARM until it

The control beeps if either door is open for more than 30 seconds.

Installation Instructions

The light goes out and the beeping stops when you close the door.

Why the WARM TEMP Light Gl