GE® Outdoor Tankless Water Heater GP94ENSRSA user guide

A product of Ecomagination.
Heavier than air and will settle on the floor.

Operating Instructions

STOP! Read the safety information above.

Set the thermostat to the lowest setting.

Turn off all electrical power to the appliance using the ON/OFF button.

Troubleshooting Tips

D. DO NOT use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

Operating Instructions

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbors phone. Follow the gas suppliers instructions.

If you cannot reach your gas supplier, call the fire department.

C. Use only your hand to push in or turn the gas control knob.

Never use tools. If the knob will not push in or turn by hand, do not try to repair it; call a qualified service technician.

Force or attempted repair may result in a fire or explosion.

Safety Instructions

FOR YOUR SAFETY, READ BEFORE OPERATING

This appliance is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand.

Locate the manual gas valve on the side of the water heater. Turn the manual valve clockwise to the full OFF position

Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! and follow B in the safety information above.

If you do not smell gas, go to the next step.

People who looking for GP94ENSRSA also looking GE® Outdoor Tankless Water Heater GP94ENSRSA user guide, GE Profile™ 30" Free-Standing Electric Double Oven Convection Range PB960BJTS user guide, GE Profile™ 7.0 Cu. Ft. Super Capacity Electric Dryer with Stainless Steel Drum DPSB620ECCC user guide, LG 32GK850F-B 32 Inch UltraGear™ QHD Gaming Monitor with Radeon FreeSync™ 2 Technology user guide, GE Profile™ 7.0 Cu. Ft. Super Capacity Gas Dryer with Stainless Steel Drum DPSB613GDWW user guide, 5.3 cu. ft. Smart Capable Top Load Washer user guide, GE Profile Prodigy™ Extra-Large 6.0 Cu. Ft. Capacity Gas Dryer DPXR483GAWW user guide, GE Profile™ ENERGY STAR® 25.6 Cu. Ft. Stainless Side-by-Side Refrigerator with Dispenser PSS26MSTSS user guide, GE® ENERGY STAR® 230 Volt Electronic Room Air Conditioner AHM24DY user guide

Turn the manual gas valve counterclockwise to the full ON position

8 Turn on all electrical power to the appliance using the ON/OFF button.

9 Set the thermostat to the desired setting. a hot water tap. If the appliance will not operate, follow the instructions

To Turn Off Gas to Appliance and call your service technician or gas supplier.

See the Installation Instructions for additional information.

Consumer Support

To Turn Off Gas to Appliance

Turn off all electrical power to the appliance using the ON/OFF button.

Set the thermostat to the lowest setting.

Locate the manual gas valve on the side of the water heater. Turn the manual valve clockwise to the full OFF position

Safety Instructions

Setting the temperature.

Hot water can be dangerous, especially for infants or children, the elderly or infirm.

There is a potential for scalding by hot water if the thermostat is set too high.

Water temperatures over 125F (51C) can cause severe burns or scalding, resulting

Hot water can cause first-degree burns with exposure for as little as:

3 seconds at 140F (60C)

20 seconds at 130F (54C)

8 minutes at 120F (48C)

Test the temperature of the water before placing a child in the bath or shower.

Operating Instructions

Do not leave a child or an infirm person in the bath unsupervised.

Temperature Ranges

Suggested temperatures are:

Kitchen: 120F (49C)

Shower: 98110F (3743C)

These temperatures are suggestions only.

Temperatures lower than 98F (37C) can be obtained at the tap by mixing with cold water.

This water heater will attempt to provide hot water at the set temperature even when the water flow is varied or when more than 1 tap is in use. The water heater can deliver water at only one temperature setting at a time. The available temperatures for a given model are provided below.

AVAILABLE TEMPERATURE SETTINGS

Troubleshooting Tips

Temp in Fahrenheit (F) 98

Temp in Celsius (C)

100 102 104 106 108 110 115 120 125 130 135 140

38 39 40 41 42 43 46 49 52 54 57 60

NOTE: The unit can display Celsius or Fahrenheit. Celsius ranges from 37 to 60 and Fahrenheit ranges from 97 to 140.

To change the temperature scale from Celsius to Fahrenheit or vice versa, turn off the unit, then press and hold the ON/OFF button for 5 seconds.

NOTE: Very small flows (a trickle) will not turn on the water heater. If you do not turn the hot faucet on enough, the water will not be hot. A typical sink faucet that is fully opened is 1.2 GPMa faucet must be flowing approximately 0.6 GPM to produce hot water.

Setting Control to Mute

To eliminate the beeps when keys are pressed or to turn the beeps back on, press and hold both the + and buttons until a beep is heard (approximately 5 seconds).

Consumer Support

HOT WATER TEMP

Setting PRIORITY for

Multiple Controllers

NOTE: If you have one remote, the priority light is always green. the Priority button on the control.

The green priority light will glow, indicating that this control is controlling the temperature and that the water heater is ready to supply hot water.

The priority can only be changed while no hot water is running.

Press the + or buttons to obtain desired temperature setting.

The water heater provides water at this temperature setting until it is changed again with this or another remote control.

While any hot water is being provided (in-use light is green), the temperature setting can only