I NSTALLATION
INSTALLING AND REMOVING
Front Controls
THE SWIVEL BASE:
BUTTON DESCRIPTION:
FOLLOW THESE
STEPS TO INSTALL THE MONITOR
1. Before you connect the cables, make sure the monitor and system unit power switches are OFF.
2. Plug one end of the 15-pin signal cable to the rear of your system.
The adapter may be required for certain Apple Macintosh computers.
Tighten the two screws on the cable connector.
3. Connect the AC-power cord into the external AC-Adapter input socket and then plug the other end of external AC-Adpater to monitors DC-power-input.
4. Plug the monitor power cables into a nearby outlet.
5. The tilt-swivel base can be adjusted for your maximum viewing comfort.
Menu button
To push menu button turns on the menu, and it activates the items you highlight.
Brightness / Select button
To adjust brightness or to choose which function you need in
OSD Menu, you may click
Contrast / Select button
To adjust contrast or to choose which function you need in
OSD Menu, you may click
Auto button
Press "A" button 2 seconds the auto adjust display mode will tune to the utmost performance according to VGA setting.
In the event of the display image needs further adjustment.
To ensure best Auto-Adjustment perfomance a. Attempt to Start/Close Windows page (No need to Shut Off) b. Press A button for 2 seconds
The monitor display will be then best adjusted.
REMARK: The highest display frequency generates at CloseWindows stage (on-off graphics pattern). Per rec. processes facilitate to best Auto-Adjustment under default environment.
Power button
Use this button to turn the monitor on and off
Power indicator
This light glows green during normal operation and glows orange during power off. Glows orange and flash during power saving mode.
ON-SCREEN DISPLAY
MENU DESCRIPTIONS
This LCD monitor features an On-Screen Display (OSD) menu. These icons are designed to make your monitor display settings easier. When highlighted, the icons illustrate the control function to assist you in identifying which control needs adjustment.
Before activating the OSD menu, the Auto button (4) can be used to automatically adjust the display to the proper size and horizontal and vertical position. (Press button for 2 seconds.)
The OSD menu activates automatically when you press the
Menu button (1) on the front of the monitor. The OSD remains centered on the screen while you make your adjustments. Use either the select button (2; 3) to move the highlight to your selection.
Pressing menu button (1) the submenu will appear nearby main menu.
The status bar indicates in which direction, from the factory preset, which adjustments are being made. Use the select button (2; 3) to adjust the control.
This control allows you to make adjustments to the contrast of the display screen.
BRIGHTNESS
The contrast and brightness menu can also be adjusted by simply pressing eiter the select button (2; 3).
When you have finished making adjustments, press the menu button (1) to save settings and exit back to main menu.
Selecting this control allows you to make adjustments to the luminosity level of the display screen.
Select this control allows you to eliminate the horizontal flickering, blurring
Select this control allows you to eliminate the vertical bars.
H-POSITION (HORIZONTAL
POSITION )
Select this control and then use the center the image horizontally on the screen. select buttons (2;3) to
V-POSITION (VERTICAL POSITION)
Select this control and then use the to center the image vertically on the screen. select buttons (2;3)
HOW TO OPTIMIZE THE DOS-MODE
MENU DESCRIPTIONS
Select this control and then use the choose on of the seven language you need. select buttons (2;3) to
1. Use the full-screen pattern which is included in your driver-disk to start
