Remove the plug from the socket before performing service or maintenance.
Before using the machine make sure that the frequency and voltage shown on the rating plate corresponds with the mains
The rating plate is located at the backside of the motor top.
Specifications and details are subject to change without prior
PLEASE READ THESE ESSENTIAL INSTRUCTIONS
(Only applicable to UK)
THIS VACUUM CLEANER is designed, developed and rigorously tested to function efficiently and safely when properly maintained and used in accordance with the following instructions. These instructions have been prepared with safety and efficiency paramount.
THE MACHINE OPERATOR must understand these instruct- ions for use, and be made aware of any relevant regulations and legislation in force at the time
CAUTION - This machine is not suitable for use in explosive or inflammable atmospheres or where such atmospheres are likely to be produced by the presence of volatile liquid or inflammable gas or vapour.
CAUTION - In no circumstances should the power supply cord be wrapped around fingers or any part of the operators person.
CAUTION - The electrical supply plug must not be subjected to undue stress by pulling on the power supply cord.
Your MACHINE must only be connected to an electrical supply of the same voltage and frequency as indicated on the rating plate. Ensure that the plug fitted to the end of the power supply cord is suitable for your supply socket, if not refer to the information contained in
'Electrical Connections', or consult a qualified electrician. The electrical installation from which the supply is drawn must be maintained to current Institute of Electrical Engineers wiring regulations.
REGULAR SERVICING and INSPECTION of your machine must be carried out by suitably qualified personnel in accordance with relevant legislation and regulations. In particular, electrical tests for earth continuity, insulation resistance, and condition of the flexible cord should be checked frequently.
In the event of any defect, the machine MUST be withdrawn from service, completely checked and repaired.
Trained Service Engineers will be pleased to carry out on site servicing on a regular or as requested basis, to ensure the continuing safety and efficiency of your
(Only applicable to UK)
220-240 volt 50 Hz machines are fitted with a 13 amp. 3 pin moulded plug. the plug is fitted with a 13 amp. detachable fuse. The correct replacement for the fuse is identified by marking or colour coding. Only fuses that are ASTA approved to BS 1362 should be fitted. Never use the plug without the fuse cover fitted. Replacement fuse covers are available at any electrical retail outlet.
If the available socket outlet is not suitable for the plug
supplied, the plug must be cut off and an appropriate plug fitted. The plug thus cut off MUST BE DESTROYED for safety reasons before being disposed of.
Machines built for other voltages and frequencies are not normally supplied with a fitted plug.
If it is necessary to fit a plug, the wires in this power supply cord are coloured in accordance with the following code:
TO CONNECT THE NEW PLUG:
If using a three-pin plug, do not make any connection to the the terminal in the plug which is marked with the letter E or by the safety earth symbol or coloured green or green & yellow. This machine is double-insulated and no earth connection is necessary. The wire which is coloured blue must be connected to the terminal in the plug which is marked with the letter N or is coloured black or blue.
The wire which is coloured brown must be connected to the terminal in the plug which is marked with the letter L or is coloured red or brown. If the plug to be fitted does not conform to the above notation then consult a qualified electrician.
MESURES DE SCURIT IMPORTANTES
LES MODLES GW 210, GW 220 ET GW 235 SONT CONUS POUR
LA COLLECTION HUMIDE ET SCHE.
USAGE COMMERCIAL OU DOMESTIQUE.
POUR VITER TOUT ACCIDENT D UNE UTILISATION INCORRECTE,
LIRE ATTENTIVEMENT TOUTES LES INSTRUCTIONS.
LIRE ET SUIVRE TOUTES LES MESURES DE SCURIT.