Using the Telephone ...
Making Calls ...
Caller ID ...
Handset Settings ...
Base Unit Settings ...
Initial Settings ...
Multi-unit User Operation...
Caller ID Compatible
PLEASE READ BEFORE USE AND SAVE.
Charge the battery for about 7 hours before initial use.
Before Requesting Help ...
Technical Information ...
Before Initial Use
Thank you for purchasing your new Panasonic digital cordless telephone.
You have acquired a KX-TCD410NL, which is a product made in regard with the European Standards for Cordless Telephones (DECT). DECT technology is characterized by high-security protection against interceptions as well as high-quality digital transmission. This telephone was designed for a wide range of applications. For example, this telephone can be used within a network of base units and handsets, constituting a telephone system which:
operates up to 6 handsets at one base unit.
allows an intercom between 2 handsets.
allows the operation of a handset at up to 4 base units, expanding the communication radio area.
Caller ID Service, where available, is a telephone company service. After subscribing to Caller ID, this phone will display the callers phone number.
Additional accessories are available for purchase. Contact your Panasonic Service
Centre for further details. 070-3314500
Do not use this unit near water.
This unit should be kept away from heat sources such as radiators, cookers, etc. It should also not be placed in rooms where the temperature is less than 5C or greater than 40C.
The AC Adaptor is used as the main disconnect device, ensure that the AC outlet is located / installed near the unit and is accessible.
TO PREVENT THE RISK OF
ELECTRICAL SHOCK, DO NOT
EXPOSE THIS PRODUCT TO RAIN
OR ANY OTHER TYPE OF
Use only specified batteries.
Only use rechargeable batteries.
Do not mix old and new batteries.
Do not dispose of batteries in a fire, they may explode.
Check local waste management codes for special disposal instructions.
Do not open or mutilate the batteries.
Released electrolyte is corrosive and may cause burns or injury to the eyes or skin.
The electrolyte may be toxic if swallowed.
Exercise care in handling the batteries in order not to short the batteries with conductive materials such as rings, bracelets and keys.
The batteries and/or conductor may overheat and cause burns.
Charge the batteries provided in accordance with the information given in this operating guide.
Batteries are supplied with this weggooien, product. When they maar inleveren are empty, you should no throw them away. Instead, hand them in as small chemical
For maximum distance noise-free operation, place your base unit:
- Away from electrical appliances such as TV, radio, personal computer or another phone.
- In a convenient high and central
The ringer tone is reproduced through the earpiece. To avoid damage to hearing, first answer the call, then hold the phone to the ear.
Only use the power supply included with the product.
Do not connect the AC Adaptor to any AC outlet other than the standard AC230V.
The apparatus is approved for use with
PQLV19CE power supply.
This apparatus is unable to make emergency telephone calls under the following conditions:
The portable handset batteries need recharging, or have failed.
During a mains power failure.
When the Key Lock is set to ON.
When the unit is in Direct Call mode.
Do not open the base unit or handset
(other than to change the batteries).
This apparatus should not be used near emergency/intensive care medical equipment and should not be used by people with pacemakers.
Care should be taken that objects do not fall onto, and liquids are not spilled into the unit. Do not subject this unit to excessive smoke, dust, mechanical vibration or shock.
Plug in the AC adaptor and the telephone line cord in order 1, 2, 3, 4.
Fasten the AC adaptor cord to prevent it from being disconnected.
The AC adaptor must remain connected at all times (It is normal for the adaptor to feel warm during use).
Never install telephone wiring during a lightning storm.
Please ensure the batteries are inserted as shown. part should be inserted first.
Close the cover as indicated by the arrow.
When you replace the batteries, part should be removed first.
To replace the battery:
Press the notch on the cover firmly and slide it as indicated by the arrow.
Replace 2 batteries and close the cover then charge the handset for about 7 hours.
At the time of shipment, the batteries are not charged. To charge, place the handset on the base unit. Please charge the batteries for about 7 hours before initial use. During charging, the battery icon is as shown below.
Needs to be
The handset which power is off will be turned on automatically when it is placed on the base unit.
In normal use, the handset and the base unit should be powered on at all times.
Battery life is dependent on use and conditions but in general when using fully charged Ni-MH batteries (700 mAh):
Talk time: 10hrs approx.
Standby time: 120hrs approx.
When using Ni-Cd batteries (250 mAh):
Talk time: 4hrs approx.
Standby time: 40hrs approx.
(Times indicated are for peak performance)
The batteries reach peak performance after several full charge/discharge cycles.
The batteries cannot be overcharged unless they are repeatedly removed and
If battery life is shortened then please check that battery and charge terminals are clean.
For maximum battery life, it is recommended that the handset is not recharged until battery icon flashes